Cuisinart CSB-78 - Cordless Rechargeable Hand Blender User Manual download pdf (Page 7)

HOLD THE BLADE RING BY THE CENTRAL HUB HOLDING RIBS (grips) (K)

ONLY. DO NOT TOUCH THE RAZOR-SHARP BLADES.

Note these important features of the blade ring. The blade ring can be

placed over the plastic blade sheath in two different ways:

If you hold it as in figure A, you will see the word “Sharp” on the blade.

Assemble the blade this side up to use the sharp edge. (See the section on

processing food, page 9, for information about when to use the sharp

edge.)

If you hold it as in figure B, you will see no writing on the blade. Assemble

the blade this side up to use the blunt edge.

See the section on processing food, page 9, for information about when to use

the blunt edge.

There are notches (K) on opposite sides of the interior of the hub. These fit over

ridges on the sides of the plastic blade sheath.

Pick up the blade ring by its hub holding ribs (grips) and turn it very slightly

clockwise. This locks it in place on the plastic blade sheath and prevents it

from sliding up during processing.

3. Connect the hand blender motor body to the top of the

chopper/grinder attachment cover. Align the spline, in

the chopper/grinder cover’s drive shaft with the ribbed

opening on the underside of the motor body. When

aligned properly, slide the two pieces together until they

mate. You will feel and hear a slight click. It may be

helpful to press the rubber release button when sliding

these pieces together.

4. With the hand blender in place, locate the chopper/

grinder cover and place it on top of the prep bowl.

Be sure that the 3 ridges (cover slots) at the top of the

prep bowl line up with the 3 notches in the underside

of the chopper/grinder cover, and that the cover

is seated all around the top of the prep bowl.

b. To rotate cover clockwise to secure it to the

prep bowl.

5. Place one hand on the cover of the chopper/grinder

attachment, while gripping the hand blender

motor body handle with the other. Press the High

or Low button with your fingers to start the motor

and run the chopper/grinder.

To turn the unit off, remove your fingers from the

selected button.

6. WHEN THE BLADE STOPS MOVING, remove the

motor body from the chopper/grinder cover, and

remove the cover from the prep bowl.

Whisk attachment

1. Align the end of the whisk (A) with the small opening

of the whisk gearbox (B).

2. Push end into opening until it locks into position (C).

3. Align the motor body with the assembled whisk

attachment and slide the pieces together until you

hear and feel the pieces click together. It may be

helpful to press the release button

when assembling.

Motor

body

bottom –

top view

Chopper/

grinder

cover –

top view

4a.

Chopper/

grinder

cover

assembly

K-NOTCH

SHARP SIDE

BLUNT SIDE UP

1 2 3 4 5 6 7 8 9 10 11 12 ... 48 49

Comments to this Manuals

No comments

Cuisinart CSB-78 - Cordless Rechargeable Hand Blender User Manual Page 7

Comments to this Manuals

Related products and manuals for Blenders Cuisinart CSB-78 - Cordless Rechargeable Hand Blender